Laboratory automation software for your experiments
Set the step logic, run the method, and watch the data come in live. No code, and it works with instruments from any manufacturer.
- Heat to setpoint
- Hold at 37 ºC
- Sample & log
Instrument control and lab automation in one place
Automate & Control is Inniti's no-code laboratory automation software. It puts instrument control, method execution, and connector state in one place. You build an experiment once, from a blank canvas or a saved template, set the step logic, and run it on your instruments while the data comes back live. You can pause, resume, and control the run from anywhere, and every finished run stays on file for you to reopen.
Create experiments
Start from a blank canvas or a saved template, then set up each step.
Set the step logic
Chain actions and conditions so the instrument runs the method the same way each time.
Watch the data live
Readings come back in real time while the experiment runs.
Review run history
Every experiment and record is saved for reference, comparison, and audit.
Build without code
Build an automated lab method, step by step
You build an experiment from a set of blocks: read an endpoint, set a value, wait, branch on a condition, or loop a section. Put them in the order your method runs, and the instrument follows that order every time.
- Read a measurement or send a setpoint to the instrument
- Conditions and loops for real methods, such as repeat until or only if
- Start blank or from a saved template so common methods stay consistent
Run in real time
Remote instrument control, in real time
When you start a run, Inniti sends the commands to the instrument and plots every reading as it arrives. You can pause, resume, or stop the run remotely, and watch several experiments at once on the same screen.
- Two-way control, so you can read data and send commands
- Live plots and current values that update as the run goes
- Pause, resume, or stop remotely without going to the bench
Stay organised
Projects, members, and a full run history
Group related work into projects and give the right people access. Every run stays on record, so you can reopen a past experiment to compare results, reuse it as a template, or hand it over with the full method and data intact.
- Organise experiments into projects with assigned members
- Every finished run saved with its readings and timestamps
- Reuse any run as the starting point for the next one
Walkthrough
In practice: automating a continuous process
Follow an example sequence as it moves through configured steps and records instrument data.
- 1
Create the experiment
Start blank or from a saved template, pick the instrument, and lay out your steps.
- 2
Set the routes
Give each step a rule, like move on after five minutes in a step, or end the run once it passes eight hours.
- 3
Start and capture live
Run it. Inniti drives the instrument and records the data and measurement history in real time.
- 4
Let it branch and loop
Steps move on by themselves as the conditions are met. Pause or stop the run remotely whenever you need to.
- 5
Review the timeline
When it finishes, go through the step timeline and data in the post-run summary, and run it again if you need to.
Why lab teams automate with Inniti
- Two-way control to read data and send commands to the instrument
- No coding to build or run a method
- Work organised into projects with the right members
- Connector state managed across every connected device
- Reusable templates keep methods consistent across the team
- Works with instruments from any manufacturer